When Performing Output Involving Pullback Movement (Or When [Tu2] Is Selected) - Roland VersaUV LEJ-640 User Manual

Use Conditions of the Media Take-up System

When Performing Output Involving Pullback Movement (or When [TU2] Is Selected)

SETUP SHEET
TU2
Never pull the media with excessive force.
If the media is pulled forcedly, it may result in interruptions during output or inaccuracy of output locations.
When using the media take-up system, to avoid pulling media with undue force, be sure to observe the fol-
lowing points.
 Never operate the MANUAL switch for the take-up unit when the loading lever is pulled back.
3
 Never press
When performing continuous printing of two or more pages
When you're performing continuous printing and take-up for two or more pages, give attention to the fol-
lowing points.
 If the setting to execute automatic cutoff of the media can be made on the computer, then turn this setting
off. Making the setting on the computer to execute automatic cutoff of the media results in media cutoff
after each page is printed. Take up quits as soon as the media is cut off.
About Length Output At One Time
If the length of output at one time is too long, the media may get soiled by touching the work floor. To avoid
the media from getting soiled by touching the floor, output the media by about 300 mm (11.8 inches). To
output by limiting the length, use the function of RIP software.
 The setting method when using Roland VersaWorks is continued on next page.
78
In using the media take-up system to perform output involving pullback move-
ment, select [TU2] of the [SETUP SHEET] menu.
When [TU2] is selected, follow the below instructions.
to pull the media back.