Using The Media Easy To Be Winkled / Hard To Be Fed - Roland VersaUV LEJ-640 User Manual

Accommodating to the Types and Condition of Media

Press

MENU
SUB MENU

|
Description
The "SIDE MARGIN" setting determines the distance from the left or right media clamp to the corresponding
left or right edge of the printing area. You can select "5 mm (3/16 inch)," "10 mm (6/16 inch)," or "25 mm (16/16
inch)." Setting this to "5 mm (3/16 inch)" lets you expand the printing area.
Note, however, that when you're using transparent media, setting this to "5 mm (3/16 inch)" may result in
printing on top of the media clamps.
The "FRONT MARGIN" setting determines the distance from the front edge of the rigid media to the printing
area. You can select "5 mm (3/16 inch)," "10 mm (6/16 inch)," or "25 mm (16/16 inch)." Setting this to "5 mm
(3/16 inch)" lets you expand the printing area.
 P. 166, "Printing Area"
5
Default Setting
[SIDE MARGIN]: 10mm (6/16 inch)
[FRONT MARGIN]: 10mm (6/16 inch)

Using the Media Easy to be Winkled / Hard to be Fed

Procedure

Press

MENU
SUB MENU

SUB MENU
VACUUM POWER
126
.
Press
the left appears.
Press
Press
the left appears.
Press
Press
Press
Only available when "SETUP SHEET" is set to "RIGID".
.
Press
Press
Press
Press
several times until the screen shown on
.
several times until the screen shown on
.
to select "25 mm (16/16 inch)."
to enable the setting.
several times to display the left figure.
.
several times to display the left figure.
.