Starting Output - Roland VersaUV LEJ-640 User Manual

Outputting

Starting Output

When the operation of page 69 "Getting Ready to Receive Data from a Computer" is completed, you can start
output. To output, the following procedure is required.
Creating Output Data
Create the output data using the application software like Adobe Illustrator and like that. For information on
2
how to create the data, refer to the documentation of your application software.
Sending the Output Data to This Machine Using the Software RIP.
Use the included software RIP "Roland VersaWorks." For information on how to install and use Roland Versa-
Works, refer to "Roland VersaWorks Quick Start Guide" and HELP of Roland VersaWorks. If using the white ink
and gloss ink, refer to "White & Gloss Ink Guide."
 Use the media clamps when using media that is less than 0.5 mm (0.02 inches) thick. Otherwise
the edges of the media may warp and catch on the print heads.
 If you are using media that is less than 0.5 mm (0.02 inches) thick, do not use the media clamps
if [HEAD HEIGHT] is set to [LOW]. The media clamps may catch on the print heads, damaging the
machine.
 P. 122, "Adjusting the Print-Head Height to Match Media Thickness"
 During output, never touch the media. Doing so may obstruct media feed or cause the media to
rub against the print heads, which may result in a paper jam or damage to the print heads.
 Keep the loading lever raised when the machine is not in use.
If ink runs out
When ink runs out, a warning beep sounds and a slot number of which ink runs out is displayed on
the display screen.
 P. 87, "How to Replace Ink Cartridges"
Before you perform lengthy printing, check the amount of ink remaining in the ink car-
tridges.
Before you perform lengthy printing, check the amount of ink remaining in the ink cartridges. When
ink runs out and printing is paused, the coloring at the seam may be altered when printing resumes.
 P. 86, "Checking for Remaining Ink"
When performing output involving pullback movement, make sure to wipe away any
grime from the pinch rollers.
If the pinch rollers are dirty when performing output involving pullback movement, an imprint from
the pinch rollers may be left behind.
70
Points that must be observed