Use Conditions of the Media Take-up System
Loading the Media onto the Media Take-up System
Note: When using the media take-up system, remove the media hold down unit and the rigid media
tables.
1.
Pass the media through the printer.
Move the dancer roller toward the rear.
3
Switch on the printer's sub power.
Load the roll media onto the printer.
2.
Fasten the media to the paper tube.
When you attach the paper tube, insert it securely onto the end caps on the take-up unit. For information on
how to install it, refer to the Setup Guide.
SETUP SHEET
TU
SETUP SHEET
TU2
LOAD SHEET
TO TAKE-UP
80
Dancer roller
[ To perform output without pullback movement ]
Press
to select "TU."
[ To perform output involving pullback movement ]
Press
and select [TU2].
Press
.
The screen shown in the figure appears.