Support For Older Unit Models - Honeywell Rapid Eye System Administration Manual

Unit Configuration Basics

Support for Older Unit Models

62
3. To start a
Maintenance
• Right-click the site name to select Maintain from the shortcut menu.
• Select the site, then click the Maintain command on the Actions menu.
• Select the site, then click
4. If the Connections dialog box appears, choose the network/dial-up connection that
you need and click OK. The maintenance tabs appear.
Site Feedback
During maintenance, messages appear in the Feedback drop-down list at the bottom fo the
Maintenance window. The messages System operational and Time zone updated...
indicate that you can proceed with the Maintenance session. For a list of messages, see
on page 73.
Feedback Box Reference
Reboot Button in Maintenance Window
The Reboot button reboots the Multi-Media unit, not your PC.
Technical Note for Network Administrators
For connections over a network, Multi-Media Maintenance sessions are sent to port 10,001.
Leave this port open in your organization's firewall for sockets used by Rapid Eye. For other
ports used by Rapid Eye, see the
Installation Guide.
Setup and Maintenance
Older-model Rapid Eye Multi-Media units are supported. If an older unit lacks a newer
feature, the feature is not shown in a
in the last available upgrade for older units. For example, a Recording tab does not appear
when running a
Maintenance Session
for the settings of recorded video.
Using Older Documentation
For the setup and operation of older-model units, Honeywell recommends referring to the
user guides that came with those units, as needed. Adobe PDF files of these older guides
are available from Honeywell technical support. See the back cover of this guide for contact
information.
Session, either:
on the toolbar.
Rapid Eye™ Multi-Media Digital Video Recorder
Session. The interface appears as it did
Maintenance
on an older-model unit. Instead, the Video tab is used