Testing A Preset; Figure 6-8 Programming A Ptz Preset; Figure 6-9 Testing Presets On A Ptz Camera - Honeywell Rapid Eye System Administration Manual

Pan, Tilt, and Zoom (PTZ) Setup

Testing a Preset

Use the dartboard
controls to test
presets (see the
following procedure)
100
9. You have the option of immediately:
• Setting up another preset. Repeat steps 4 to 8, using another preset in step 5.
• Testing the preset. See
• Setting presets for another PTZ camera at that site.
Figure 6-8 Programming a PTZ Preset
Figure 6-9 Testing Presets on a PTZ Camera
1. You have the option of running either:
• A Session. Click the Video tab, select a PTZ camera to test presets
Maintenance
with, and click PTZ. The PTZ dartboard controller displays.
• A Live Session. Select or add a video stream from a PTZ camera. Click Enable
PTZ Control (
2. On the dartboard control, set the drop-down arrow to Preset (see
3. Click the numbered buttons above the Preset box. The PTZ camera moves to the
preset position. Check your configuration if the camera does not move. Either:
• A preset has not been set for that number.
• The preset duplicates the settings of the previously used preset.
• The camera is labeled as PTZ but is not.
on page 100.
Testing a Preset
Select a preset from the drop-down list.
You can change the name by entering
one in the box. Click Save Preset when
you are finished programming.
). The dartboard controller displays.
Test presets by
starting a live
session,
right-clicking on
video from a PTZ
camera and
selecting a preset
Figure 6-9).