Dial-Up Connection To An Alarm Station; Preparing A Dial-Up Connection To An Alarm Station; Figure 11-5 Multi-Media Unit Calls An Alarm Station To Report An Alarm; Table 11-3 Router Mappings: Example For Unit Callback To Alarm Stations - Honeywell Rapid Eye System Administration Manual

Multi-Media Alarm Stations

Dial-Up Connection to an Alarm Station

Multi-Media
unit

Preparing a Dial-Up Connection to an Alarm Station

222
Table 11-3 Router Mappings: Example for Unit Callback to Alarm Stations
Admin setting to: destination
NAT Port (to network
router)
Alarm station C
Callback Port: 56,080 164.178.32.59
Alarm station D
Callback Port: 56,090 map as above
a
Alarms are sent to port 10,003. For other ports used by Multi-Media units, see the
Rapid Eye™ Multi-Media Digital Video Recorder Installation
Figure 11-5 Multi-Media Unit Calls an Alarm Station to Report an Alarm
READY
ALARM
HDD
TM
Modem
Multi-Media units can use a telephone line to connect to the modem of an alarm station, or
its RAS server. Telephone lines can be either a plain old telephone system (POTS), or
higher speed integrated services digital network (ISDN). You also need to know the
telephone number to reach that modem.
Microsoft Windows
To send alarms over a dial-up connection, you will need to obtain a point-to-point protocol
(PPP) username and password for the PC used as an alarm station, or for its RAS server,
from their Microsoft Windows operating system. See
an Alarm Station's Definition
Router's Outside IP
(network constant)


POTS or ISDN
Modem
Modem
Point-to-Point Protocol (PPP) Fields in
on page 218.
Network device: mappings
Physical Port Inside IP
(unit & firewall) (alarm station)
a
10,003 10.1.0.78
a
10,003 10.1.0.79
Guide.
Multi-Media
Alarm Station