Last Valid Password - Honeywell Rapid Eye System Administration Manual

Security for a Multi-Media System

Last Valid Password

TIP!
190
4. Remove the asterisks from the unit Password and Confirm Password fields. See
10-5, above. This does not remove your system password from other units.
Figure
5. Click Save and Close.
6. Using View, start a
Maintenance Session
7. To set the unit to your system password, click Update Security on the Security tab.
8. Tell any logged on View Operators that they need to refresh the Multi-Media database
to use the new site (see
will have their local database automatically refreshed the next time that they log on to
View.
If the Site Cannot be Accessed
You may have left asterisks behind in the unit Password and Confirm Password fields.
The scenarios described below are exceptions. They only apply when dealing with
re-entry of information in a site definition for used units.
Last Valid System Password
When your Multi-Media system administrator (Multi SA) adds a site definition, the last
valid password (LVP) entry for that site remains blank in your Multi-Media central
database. When a system password is added, this database entry is updated along with
the unit. There are situations when a discrepancy can occur between the system password
held by a unit and the system password entry in the Multi-Media database. An LVP utility is
available to resolve these discrepancies.
The LVP utility may need to be used if you:
• Obtain a used unit, from another organization's Multi-Media system. A Multi-Media
unit may still be protected by a system password. You may need to contact the other
organization's Multi SA.
• Delete a site definition by mistake. When a system password is in use and a site is
deleted by mistake, you need a few extra steps to re-enter the site definition, as a
system password is in use on the unit.
Note If a site definition is deleted by mistake, but no system password has been
set, you can disregard using the LVP when re-entering the site. See
on page 35.
Site
Entering a Site Definition for Another Unit
If you have obtained a unit from another user and you suspect that the system password
on that unit was not removed, use the next procedure.
for the site.
Refreshing a Local Database
on page 274). Occasional users
Adding a