Ptz Serial Device; Assigning And Setting A Ptz Device; Hardware Report - Honeywell Rapid Eye System Administration Manual

PTZ Serial Device

Assigning and Setting a PTZ Device

Hardware Report

Document 800-07769 Rev A
02/11
A PTZ serial device is only used to control cameras that pan, tilt and zoom (PTZ). A Multi
SA obtains the Multi-Media unit's port number that is used for PTZ functions from the
installers of a Multi-Media system or by taking note of the back panel of the unit.
PTZ Device Settings
A PTZ device is set using a
PTZ settings on the Video tab. See
1. Consult the installer to find out which serial port of the unit the PTZ cameras are
connected to. If more than one PTZ camera shares the same serial communications
line, make a note of the address set on each camera.
2. Continue or start a
Maintenance Session
3. Click the Serial Devices tab. A PTZ device is either:
• Assigned to a Port. Click PTZ. The settings are displayed and can be changed.
• In the Unassigned Devices group. Click PTZ. The settings are displayed and can
be changed.
• In the New Devices group. Drag the PTZ icon and drop it either on the
Unassigned Devices group or on a Port. If you drop it on a port that is already
assigned to another device, the PTZ device replaces it. The displaced device is
sent to the Unassigned Devices group.
4. Change the values to those suggested by the PTZ camera documentation.
5. Drag the modem icon to the port icon with the number of the port identified in
During a
Maintenance Session
The report includes a serial number of the Multi-Media unit on the Rapid Eye site, the
version of software running the Multi-Media unit, the date of manufacture, and internal
hardware used by the unit.
Rapid Eye DVR System Administrator Guide
Session, on the Serial Devices tab. It enables the
Maintenance
Pan, Tilt, and Zoom (PTZ) Setup
for the Rapid Eye Multi-Media site.
for the Rapid Eye Multi-Media site, click the Hardware tab.
on page 93.
step 1.
153