Table of Contents
Advertisement
Recording the Installation Details
Rear Panel Connections
Spot monitor
video output
SPOT
MONITOR
VIDEO
INPUTS
Connector label
Description
VIDEO INPUTS
BNC connectors for video input. A Rapid Eye LT can have 4 or 8 video input connections.
VIDEO OUTPUTS
BNC connectors to relay a video feed to either a CCTV, NTSC or PAL monitor, VCR, or other
device. The outputs are capped for delivery.
SPOT MONITOR
BNC connector; can be set to produce a camera tour on a spot monitor.
VGA PORT
For an optional VGA monitor (not supplied), needed for LocalView.
TELCO
RJ11 connector to the modem of the Multi-Media LT DVR (North America only).
USB PORTS
For the USB mouse (supplied) and USB keyboard (not supplied). Can be used to burn clips
on a USB mass storage device.
LAN
RJ45 connector to 10/100 BT network card in the DVR.
Document 800-07766V1 Rev A
02/11
As you start connecting hardware to the Multi-Media LT DVR, Honeywell recommends that
you make a record of system information (such as the IP address) with the site information
checklist (provided in
Appendix
and changes to the Rapid Eye site configuration using LocalView.
shows the rear panel connections on an 8-channel unit, and
Figure 2-1
the connections.
Figure 2-1
Rear Panel Connectors on 8-Channel Multi-Media LT Unit
Video inputs and outputs, for cameras
(LT units can have 4 or 8 inputs/outputs)
1
2
3
4
SERIAL PORT 2
SERIAL PORT 1
VGA
Communication ports
Serial ports
1 and 2
Table 2-2
Rear Panel Connectors
Rapid Eye™ LT DVR Installation Guide
D). Include a record of the hardware connected to the DVR
Alarm and control
connectors
5
6
7
8
TELCO
LAN
IN
OUT
115-230V~
50/60 Hz
NOT
5-3A
USED
USB
USB
describes
Table 2-2
Serial ports
3 and 4
COMMON
CONTROL
SYS FAIL
OUTPUTS
SERIAL
SYS GOOD
1 G
2
G
3
G
4
G
PORT 3
FAULT
RELAY
28V, 3A
MAX
SERIAL
PORT 4
1 G
2
G
3
G
4
G
5 G
6
G
7
G
8
G
ALARM
INPUTS
Power
switch
ON/OFF
POWER
25
Advertisement
Table of Contents
