Thermal Adhesive - GBC Orca 1600 Operation And Maintenance Manual

Maintenance
d) Set a slow speed of less than 3 ft/ min. ( 91 cm/
min. ).
e) Put on the rubber gloves and use the isopropyl
alcohol and terry cloth towel to rub where the
dirt is on the rollers.
E xcessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
IN F O R M AT IO N
K eep the terry cloth tow el kind of dam p to
m ake the rubbing of the roller sm ooth.
f) Use the footswitch to rotate the roller to a new
spot to clean.
g) Do this as many times as needed to clean the
laminator rolls.
Page 8 - 4
C AU T IO N
Orca 1600 Operation and Maintenance Manual

8.5 Thermal adhesive

a) Allow the laminator to cool slightly, no higher
o
than 110 F ( 43
< 1 1 0
CA L 32 00
C L E A N IN G H E A T E D R O L L E R S C A N
IG N IT E T H E FU M E S!
b) Set the machine direction to FWD when cleaning
the pull rollers. Set the machine direction to REV
when cleaning the main rollers.
FW D
R E V
( if cleaning
pull rollers )
c) Remove the front table and table idler to gain more
access to the main rollers or remove the rear table
to gain more access to the pull rollers.
© GBC Films Group February 2001
o
C ).
< 1 1 0
CA L 32 00
C AU T IO N
FW D
O R
R E V
( if cleaning
m ain rollers )