Main Roller Nip - GBC Orca 1600 Operation And Maintenance Manual

Orca 1600 Operation and Maintenance Manual
Unloading a roll of film
a) Cut the laminate from the web.
D o not use an open blade to cut
the w eb near the rollers.
Y ou can put cuts into the rollers!
b) Pull up on the clevis pin.
c) Swing the unwind shaft out away from the
laminator.
( U p p e r u n w in d s h a ft s h o w n fo r illu s tra tio n p u rp o s e s )
d) With a little twist on the roll of film, pull the
roll off of the unwind arm.
e) If finished, swing the unwind arm back into
its unwind support saddle and push the clevis
pin down. If not, follow the Load a roll of
film procedure again from step d).
© GBC Films Group February 2001
C AU T IO N

5.7 Main roller nip

To set the main roller nip for use with
substrates can easily be obtained by setting the shim
dials on the main roller to the desired opening.
a) Ensure the upper main roller is in the up
position.
IN F O R M AT IO N
T he nip can only be changed w ith the
upper roller in the up position.
b) Turn the shim dial to the desired setting.
( vie w e d fro m th e to p o f la m in a to r )
S h im d ia ls
F ro n t o p e ra tin g p o s itio n
c) Adjust main roller pressure for the desired
setting with respect to the substrate being used.
d) Press the main roller UP/ DOWN switch to
DOWN.
Operations
Page 5 - 11