Installing Levelers - GBC Orca 1600 Operation And Maintenance Manual

Installation
b) Set the main air in pressure to 70 pounds per
square inch (psi) (500 kPa) by turning the air
regulator knob.
IN F O R M AT IO N
T he upper m ain roller and the upper pull
roller should be in the raised position.
c) Close the control side cabinet and secure with the
factory bolts.
Page 4 - 12
Orca 1600 Operation and Maintenance Manual

4.9 Installing levelers

you choose not to level the laminator and you encounter
output problems, please level the machine and try your
100
application again before calling for technical support.
Resting the laminator on the leveling pads will prevent the
machine from rolling during set up, operation or servicing.
R e g u la to r
k n o b
• ( 1 ) 1/2 in. open end wrench
• ( 1 ) 7/8 in. open end wrench
• Four leveling pads
a) Be sure that the machine is placed where you
b) Secure the four leveling pads onto the four foot
c) Use the 1/2 in. wrench on the foot bolt and the
Leveling of the machine is a customer option. If
Tools required
( from the accessory pack )
want it to rest.
bolts.
7/8 in. wrench on the leveling pads and tighten
them together.
1/2 W renc h
© GBC Films Group February 2001
7/8 W renc h