Clean The Laminator - GBC Orca 1600 Operation And Maintenance Manual

Orca 1600 Operation and Maintenance Manual
d) Set a slow speed of less than 3 ft/ min. ( 91 cm/
min. ).
D o N O T pick or pull heat activated adhesive
off the rolls w hen they are cold. Y ou can
cause irreparable dam age to the
lam inating rolls.
e) Put on the rubber gloves and use the rubber
cement eraser to bead up the adhesive.
f) Use the footswitch to rotate the roller to a new
spot to clean.
g) Do this as many times as needed to clean the
laminator rolls.
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
c) Wipe away the beads with isopropyl alcohol
and a cotton terry cloth.
© GBC Films Group February 2001
C AU T IO N
CAUTION

8.6 Clean the laminator

Remove power from the laminator before
cleaning. You can be severely shocked,
electrocuted or cause a fire.
a) Use a damp cotton terry cloth ( water only ),
clean the exterior of the laminator.
b) If water is not strong enough, you may use a
mild dishwashing detergent with water and a
cotton terry cloth.
Do not use liquid or aerosol cleaners on the
laminator. Do not spill liquid of any kind on
the laminator. You can be severely shocked,
electrocuted or cause a fire. Use only a damp
cloth for cleaning unless other wise
specified.
Maintenance
ELECTRICAL
S H O C K
ELECTRICAL
S H O C K
Page 8 - 5