Load A Roll Of Film; Film Loading/ Unloading - GBC Orca 1600 Operation And Maintenance Manual

Operations

5.6 Film loading/ unloading

The Orca 1600 utilizes a swing out unwind
arm for simple loading and unloading of film. Always
pay particular attention to which side of the laminate
is the adhesive side and which side is the laminate
side. The adhesive side should always face away from
the face of the rollers.
P o ly-in film

Load a roll of film

a) Adjust the core chucks to fit within the roll of
film being used. The roll of film should be
approximately center of the main rollers. The
core chucks should be close to the edge of the
roll of film.
R o ll o f film
C o re c h u c k C o re s u p p o rt
Page 5 - 10
Orca 1600 Operation and Maintenance Manual
P o ly-o u t film
C o re c h u c k
b) Pull up on the clevis pin to the unwind support
saddle you are about to load a roll of film to.
C le v is p in
U n w in d su p p o rt s a d d le
c) Swing the unwind arm out away from the
machine.
( U p p e r u n w in d s h a ft s h o w n fo r illu s tra tio n p u rp o s e s )
d) With respect to the adhesive side of the roll,
slide the roll of film onto the unwind arm.
e) Swing unwind arm back into the unwind arm
support saddle and push the clevis pin down.
( U p p e r u n w in d s h a ft s h o w n fo r illu s tra tio n p u rp o s e s )
© GBC Films Group February 2001