Loading Top Mount Adhesive; Loading Bottom Thermal Film - GBC TALON 44 Operation And Maintenance Manual

Fig. 24
Fig. 25
38

LOADING TOP MOUNT ADHESIVE

This procedure describes how to
load a roll of mount adhesive using
the upper position for pre-coating
(Figure 24).
1. Turn the Power ON/OFF to on
(I). If the laminator is already
hot, turn POWER ON/OFF to the
off (O) position and allow the
unit to cool. Once cool, turn the
laminator back on.
2. Ensure no brake tension is
applied to the film shaft.
3. Remove the safety shield.
4. Set the roll of mount adhesive in
the upper rear unwind/ rewind
position.
5. Pull the mount adhesive over the
upper idler and upper main roller
allowing the material to rest on
the top of the feed table.
6. Reference THREADING CARD
PROCEDURE next.
LOADING BOTTOM THERMAL
FILM
This procedure describes how to
load a roll of thermal film using the
lower unwind position for encap-
sulation (Figure 25).
1. At this point you should have an
upper roll of thermal film loaded
onto the laminator.
2. Ensure no brake tension is
applied to the film shaft.
3. Guide the bottom film around the
lower idler.
3. Adhere the film to the loaded
upper roll of thermal film by
pulling the film up towards the
existing draped thermal film over
the main rollers.
NOTE: You may follow this
procedure to load a roll of Kraft
Paper for single side lamination.
4. Reference THREADING CARD
PROCEDURE next.
I