Table of Contents
Advertisement
Operations
5.5 Manual nip adjustment
If the substrate does not fall with in the preset
GAP settings available, a manual nip setting must be
performed.
If you are unsure of a substrate thickness, it is
recommended that you use the manual nip setting
procedure.
If you are performing a mounting application from
the rear of the machine, the pull rollers must be set manually.
Refer to Section 5.5.2 Pull roller nip adjustment
procedure.
5.5.1 Main roller manual
nip adjustment
INFORMATION
The laminator will only turn on if all
E-STOPS are unlatched and
the E-CABLE is reset.
Page 5 - 18
F - 160 CE Operation and Maintenance Manual
a) Turn the MAIN POWER to the " I "
position.
Power
ON/OFF
b) Press RESET. The front control panel will
illuminated.
Machine reset
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
© GBC Films Group April 2000
WARNING
Advertisement
Table of Contents
