Wall Mounting - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide
6. Insert a top mounting screw (not included) in one side and turn it several turns to
establish support. Repeat for the other side.
7. Tighten the screws.

Wall Mounting

You can mount the Gateway to a wall using the two mounting slots on the bottom of the
device. Ensure that the device is oriented as shown in Figure 3 to allow air to flow
vertically through the ventilation holes on each side of the device.
To mount the Gateway to a wall:
1. Install two pan-head screws (with ¼-inch diameter head) 7 ⅞ inches (20 cm) apart.
The screw shaft diameter should be ⅛-inch (3.2 mm). Ensure you use anchors
appropriate for your mounting surface. Leave about ⅛-inch (3.2 mm) clearance
between the screw head and the wall.
2. Position the device with the mounting slot centers aligned over the mounting screws.
Carefully bring the device down onto the screws.
3. Slide the device downwards so that the screws go into the mounting slots on the
device. Ensure the device is secure.
Installation
Figure 3. Wall Mount Orientation
16
Back to Contents