Removal procedures
Keep the following tips in mind as you replace parts:
•
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to avoid
pinching wires, obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging unit, and media tray before removing other printer parts. The imaging unit
should be carefully set on a clean, smooth, and flat surface. It should also be protected from light while out of the
device.
•
Disconnect all external cables from the printer to prevent possible damage during service.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held with several screws, start all screws before the final tightening.
Base printer - cover removals
•
"Left cover removal" on page 277
•
"Rear lower cover removal" on page 280
•
"Top cover removal" on page 282
•
"Right cover removal" on page 283
•
"Rear door removal" on page 285
Left cover removal
1
Open the front door.
2
Pull the media tray from the machine.
Repair information
277
4063