Lexmark MS81x Service Manual page 146

Error code Description
243.01 Media remains detected by the tray 3 sensor (pass
through) after power on.
243.02 The media is late reaching the sensor (input) when
feeding from tray 3.
243.03 The media fed from tray 4 did not reach the tray 3
sensor (pass through).
243.06 Failure to feed from tray 3—media remains in tray 3
243.07 The media while feeding from tray 4, remains
detected by the tray 3 sensor (pass through).
243.09 Tray 3 pick motor lost encoder error
243.10 Failure to feed from tray 3
Action
1
POR the printer.
2
Open the media trays and make sure there are
no obstructions on the media path.
3
Check the following:
•
•
•
4
If only one option is installed, re‑seat the option
tray. If there are multiple options installed, swap
the current option with another matching media
tray to determine the source of the error.
If the error persists, then perform the following
service checks:
•
•
Make sure the media path is free from obstructions
on the following locations:
1
Open all input media trays and make sure there
are no obstructions on the media path.
2
Remove the toner cartridge and the imaging unit.
Make sure there are no obstructions on the
media path.
3
Open the rear door, and make sure there are no
obstructions on the media path.
4
Check all output bins. Make sure there are no
obstructions on the media path
If the error persists, then perform the following
service checks:
•
For 250/550‑sheet trays—go to
media tray option jam service check" on
page 154
• For HCIT—go to
on page 159
Diagnostic information
146
Make sure the size of the media loaded is
within specifications.
Make sure the tray guides are not set too
tight.
Make sure the tray is not overfilled.
For 250/550‑sheet trays—go to
sheet media tray option jam service check"
on page 154
For HCIT—go to "HCIT jam service check" on
page 156
"HCIT source jam service check"
4063
"250/550-
"250/550-sheet