Engine Setting [X]; Edge To Edge; Parallel Strobe Adjustment (Par 1 Strobe Adj); Ep Setup - Lexmark MS81x Service Manual

From the Diagnostics menu, navigate to PRINTER SETUP > Processor ID.

Engine Setting [x]

These settings are used by the Engine code to further customize the behavior of the printer to applications. The value
of [x] is any value from 1 to 16.

Edge to Edge

When set to On, this shifts all four margins (top, bottom, left, and right) to the physical edge of the page (printable area
of a supported paper size). This feature does not work in PPDS emulation.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Edge to Edge.

Parallel Strobe Adjustment (Par 1 Strobe Adj)

This setting adjusts the factory setting for the amount of time the strobe is sampled to determine that valid data is
available on the parallel port.
Each time the value is increased by one, the strobe is sampled 50 nanoseconds longer. Each time the value is decreased
by one, the strobe is sampled 50 nanoseconds less than the default value. The range of values is between -4 and +6, in
increments of one. A value of zero indicates no change is made from the factory setting.
To change this setting:
From the Diagnostics menu, navigate to PRINTER SETUP > Par 1 Strobe Adj.

EP SETUP

EP Defaults

This setting restores each printer setting listed in EP SETUP to its factory default value. Sometimes this is used to help
correct print quality problems.
To restore the EP defaults:
1
From the Diagnostics menu, navigate to:
EP Setup > EP Defaults
2
Select Restore to restore the default values, or press X to exit without changing the settings.

Fuser Temperature (Fuser Temp)

This setting adjusts the fuser temperature to solve problems with paper curl on low‑grade paper and/or melting of
letterheads on some papers.
To adjust this setting:
1
From the Diagnostics menu, navigate to:
EP Setup > Fuser Temp
2
Press OK or touch to save any changes.
Service menus
238
4063