UI Automation
When enabled, this setting creates an ENABLE_UI_AUTOMATION file in the /var/fs/shared/ directory. As long as this
file exists, the printer permits external developers to test the stability of their applications against the printer to make
sure that their applications have an appropriate level of stability. Disabling this setting deletes the file and prohibits
automated testing.
To change the setting:
1
From the Configuration Menu, navigate to UI Automation.
2
Select from the available options to change the setting.
•
Enable
•
Disable (default)
3
Depending on the printer model, press OK or touch
Menu without saving any changes.
LES Applications
This setting enables or disables all installed Lexmark Embedded Solution applications.
To change this setting:
1
From the Configuration Menu, navigate to LES Applications.
2
Select from the available options to change the setting.
•
Enable (Default)
•
Disable
3
Depending on the printer model, press OK or touch Back to save the setting, or press X to return to the Configuration
Menu without saving any changes.
Key Repeat Initial Delay
Note: This setting is available on the touch screen model only.
This setting determines the length of delay before a repeating key starts repeating. The range is 0.25–5 seconds, with
increments of 0.25. The default setting is one second.
To adjust this setting:
1
From the Configuration Menu, navigate to Key Repeat Initial Delay.
2
Touch the arrow keys to adjust the setting.
3
Touch
to save the setting, or press X to return to the Configuration Menu without saving any changes.
Key Repeat Rate
Note: This setting is available on the touch screen model only.
This setting indicates the number of presses per second for repeating keys. The range is 0.5–100, with increments of
0.5. The default setting is 15 presses per second.
to save the setting, or press X to return to the Configuration
Service menus
250
4063