Lexmark MS81x Service Manual page 168

Error code Description
452.73 Finisher/offset stacker left tamper failed to leave its
home position
452.74 Finisher/offset stacker left tamper failed to reach its
home position
453.75 Finisher/offset stacker right tamper failed to leave its
home position
453.76 Finisher/offset stacker right tamper failed to reach its
home position
454.41 Finisher/offset stacker ejector motor stalled
454.42 Finisher/offset stacker ejector motor did not reach
the required speed.
454.43 Took too long to ramp up ejector motor in the
finisher/offset stacker
454.53 Finisher/offset stacker main/interface motor went
over the normal speed.
454.77 Finisher/offset stacker left tamper failed to leave its
home position
454.78 Finisher/offset stacker left tamper failed to reach its
home position
Action
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
tamper jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
tamper jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
1
POR the printer.
2
Reseat all the installed output options on the
printer.
3
Clear obstructions along the paper path.
4
Make sure that the sensors (pass through) are
free from obstructions.
5
Close the rear door properly.
If the problem remains, then go to
jam service check" on page
Diagnostic information
168
4063
"Finisher left
181.
"Finisher right
182.
"Finisher ejector
184.
"Finisher ejector
184.