Table of Contents
Advertisement
Action
Step 7
Open the rear door, and check:
•
if the rear door opens and closes properly
•
the rollers for damage
Is the above component ok?
Step 8
Open the left cover and check the feed gears. If damaged, then replace
the staple finisher assembly. Go to
on page
471.
Reseat the connector (J3) on the controller PCBA, then POR the machine.
Does the error remain?
Step 9
Remove the staple finisher assembly from the printer. Check the feed
rollers and gears under the staple finisher.
Is if free of damage?
Step 10
Open the top cover, check the left media stack flap:
•
for damage
•
if it is not dislodged from its original position
•
if it has no problem moving when manually actuated
Is the above component ok?
Step 11
Check the right media stack flap:
•
for damage
•
if it is not dislodged from its original position
•
if it has no problem moving when manually actuated
Is the above component ok?
Step 12
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?
"Staple finisher assembly removal"
Diagnostic information
180
Yes
No
Go to step 8.
Replace the rear door.
Go to
door removal" on
page 472
Go to step 9.
The problem is solved.
Go to step 10.
Replace the staple
finisher assembly. Go
to
assembly removal" on
page
Go to step 11.
Replace the left media
stack flap. Go to
"Media stack flap (left)
removal" on page
486.
Go to step 12.
Replace the right
media stack flap. Go to
"Media stack flap
(right) removal" on
page
Replace the controller
The problem is solved.
PCBA. Go to
"Stapler
controller PCBA
removal" on page
496.
If the error persists,
then replace the staple
finisher. Go to
"Staple
finisher assembly
removal" on page
471.
4063
"Stapler rear
"Staple finisher
471.
485.
Hide quick links:
Advertisement
Table of Contents
