Main Switch Removal - Daewoo Nubira Owner's Manual

DAEWOO V–121 BL4
CRUISE CONRTOL SYSTEM 9U – 17
2. Align the cable housing and push the cable housing
onto the actuator until it is locked in place by the
retainers.
3. Insert the cable adjuster into the bracket of the ped-
al mount assembly.
4. If the adjuster spring is not fully compressed, press
the cable release button and slide the cable into the
adjuster until the spring is fully compressed.
5. Install the cable bushing into the pedal assembly.
6. Press the cable release button and adjust the cable
to achieve a gap of 0.5 mm (0.02 inches) between
the bushing and the nipple of the ball.
MAIN SWITCH
Removal Procedure
1. Remove the radio, taking care not to scratch the
instrument panel or trim with the corners of the ra-
dio case. Refer to Section 9F, Audio Systems.
2. Reach through the radio opening in the instrument
panel and wiggle the cruise control main switch to
loosen it.
3. Push the cruise control main switch out of the in-
strument panel.
4. Disconnect the electrical connector from the cruise
control main switch.