Daewoo Nubira Owner's Manual page 57

1C – 18IDOHC ENGINE MECHANICAL
50. Disconnect the fuel return line at the fuel pressure
regulator.
51. Disconnect the fuel feed line at the fuel rail.
52. Remove the generator adjusting bracket retaining
bolt and the bracket.
53. Disconnect the coolant hose at the rear cylinder
head and ignition coil exhaust gas recirculation
(EGR) bracket.
54. Disconnect the surge tank coolant hose at the
throttle body.
55. Remove the fuel rail assembly. Refer toSection 1F,
Engine Controls.
56. Remove the generator–to–intake manifold support
bracket bolts at the cylinder head and the intake
manifold.
57. Remove the generator support bracket.
58. Remove the intake manifold–to–generator strap
bracket bolt and loosen the bolt on the generator.
59. Move the strap clear of the intake manifold.
60. Remove the evaporative emission canister purge
solenoid bracket bolt and move the bracket clear.
61. Disconnect the throttle cable at the throttle body
and the intake manifold.
62. Loosen all of the cylinder head bolts gradually and
in the sequence shown.
63. Remove the cylinder head bolts.
64. Remove the cylinder head with the intake manifold
and the exhaust manifold attached.
Notice : Prevent any engine oil or coolant from entering
the cylinders when removing the cylinder head.
65. Remove the cylinder head gasket.
DAEWOO V–121 BL4