Brake Hose Rear Removal; Brake Hose Rear Installation - Daewoo Nubira Owner's Manual

4A – 14IHYDRAULIC BRAKES
BRAKE HOSE REAR
Removal Procedure
1. Raise and suitably support the vehicle.
2. Disconnect the brake line from the disc brake hose
at the wheel housing bracket on each side of the
vehicle.
3. Remove the brake hose retainer.
4. Remove the rear disc brake hose retainer and the
brake hose from the bracket on the steering
knuckle shaft.
5. Remove the rear disc brake hose from the caliper.
Installation Procedure
1. Install the rear disc brake hose to the caliper.
Tighten
Tighten the rear disc brake hose–to–caliper bolt to 32
NSm (24 lb–ft).
2. Install the rear disc brake hose and retainer on the
bracket on the steering knuckle shaft
3. Install the rear disc brake line to the brake hose on
the wheel housing bracket.
Tighten
Tighten the brake line to 16 NSm (12 lb–ft).
4. Lower the vehicle.
5. Bleed the brake system. Refer to"Manual Bleeding
the Brakes"in this section, or Section 4F, Antilock
Brakes, if applicable.
6. Check the brake system for leaks.
DAEWOO V–121 BL4