Autolocking (Safety Lock); Control Module/Receiver; Fault Of Alarm Indication; Panic Button - Daewoo Nubira Owner's Manual

9T – 12IREMOTE KEYLESS ENTRY AND ANTI–THEFT SYSTEM
S
The door is opened with the key.
S
The rear deck lid is opened with the key.
S
The UNLOCK button or the LOCK button on the
remote transmitter is pressed within 2 seconds of
the beginning of the alarm. If the UNLOCK button
or the LOCK button is not pressed within 2 seconds
of the beginning of the alarm, the transmitter will
not stop the alarm.

VEHICLE LOCATOR

The remote keyless entry system assists the driver in lo-
cating the vehicle. When the vehicle is unlocked with the
remote control, the turn signals flash twice to indicate the
location of the vehicle. The duration of the flashes and the
length of time between flashes is used to indicate certain
vehicle conditions. Refer to "Fault or Alarm Indication" in
this section.

AUTOLOCKING (SAFETY LOCK)

The remote keyless entry system features an autolocking
control. If the doors are unlocked with the remote transmit-
ter when the control module/receiver is in the armed
mode, the doors are automatically re–locked after 30 sec-
onds unless any of the following events occur:
S
The door is opened.
S
The ignition switch is turned ON.
S
The rear deck lid is opened.
S
The hood is opened.

CONTROL MODULE/RECEIVER

The remote keyless entry control module/receiver is con-
tained in the floor console. The module/receiver pro-
cesses signals from the remote transmitter and the intru-
sion sensors, and it activates the alarm if an intrusion is
detected. The control module/receiver also has a selfdiag-
nostic function which will display trouble codes. In order to
display trouble codes, a scan tool must be connected to
the assembly line diagnostic link (ALDL) connector.
The control module/receiver will not communicate with
transmitters from other vehicles because there are over
four billion possible electronic password combinations,
and passwords are not duplicated. The control module/ re-
ceiver has an attached antenna to detect signals from the
transmitter.
FAULT OR ALARM INDICATION
When the UNLOCK button on the remote transmitter is
pressed, the control module/receiver will flash the parking
lamps to indicate information about the remote keyless
entry and anti–theft system.
Normal Condition: If there has not been an intrusion, and
no fault has been detected, the control module/receiver
will signal a normal condition when the UNLOCK button is
pressed. The parking lamps will flash twice for 0.5 second,
with a 0.5 second pause between flashes.
Fault Indication: If there is a fault in the remote keyless
entry and anti–theft system, the control module/receiver
will signal the fault when the UNLOCK button is pressed.
The parking lamps will flash twice for 1 second, with a 0.5
second pause between flashes.
Alarm Indication: If there has been an intrusion since the
last time the LOCK button was pressed, the control mod-
ule/receiver will signal that there has been an intrusion
when the UNLOCK button is pressed. The parking lamps
will flash twice for 0.5 second, with a 1.5 second pause be-
tween flashes.
Alarm and fault information in the control module/receiver
will be erased the next time the controlmodule/receiver en-
ters the armed condition after receiving a LOCK message
from the transmitter.

PANIC BUTTON

In addition to the LOCK and UNLOCK buttons on the
transmitter, there is the panic button. This button is used
to activate the siren if a threatening situation occurs while
the driver is approaching the vehicle. If the panic button is
held down for 2 seconds, the siren will be activated for 30
seconds, and the parking lights will flash during that time.
DAEWOO V–121 BL4