Crankshaft Bearing And Connecting Rod Bearings - Gauging Plastic; Inspection Procedure – Crankshaft - Daewoo Nubira Owner's Manual

1C – 88IDOHC ENGINE MECHANICAL
62. Install the flywheel or flexible plate.
63. Install the flywheel or the flexible plate bolts.
Tighten
Tighten the flywheel bolts to 65 NSm (48 lb–ft). Use
the angular torque gauge KM–470–B to tighten the
flywheel bolts to 30 degrees plus 15 degrees. For the
automatic transmission, tighten the flexible plate bolts
to 65 NSm (48 lb–ft).
64. Install the engine. Refer to "Engine"in this section.
CRANKSHAFT BEARINGS AND
CONNECTING ROD BEARINGS –
GAUGING PLASTIC
Tools Required
KM–470–B Angular Torque Gauge
Inspection Procedure – Crankshaft
1. Coat the crankshaft bearings with engine oil.
2. Install the upper crankshaft bearings into the engine
block crankshaft journals.
3. Install the lower crankshaft bearings into the crank-
shaft bearing caps.
4. Install the crankshaft.
5. Inspect the crankshaft end play with the crankshaft
bearings installed.
6. Check for permissible crankshaft end play. Refer to
"Engine Specifications"in this section.
7. With the crankshaft mounted on the front and rear
crankshaft bearings, check the middle crankshaft
journal for permissible out–of–round (runout). Refer
to "Engine Specifications"in this section.
DAEWOO V–121 BL4