General Description And System Operation; General Repair Instructions - Daewoo Nubira Owner's Manual

0B – 16IGENERAL INFORMATION
GENERAL DESCRIPTION
AND SYSTEM OPERATION

GENERAL REPAIR INSTRUCTIONS

If a floor jack is used, the following precautions are recom-
mended:
S
Park the vehicle on level ground, "block" the front or
rear wheels, set the jack against the frame, raise
the vehicle and support it with chassis stands, and
then perform the service operation.
S
Before performing the service operation, disconnect
the negative battery cable to reduce the chance of
cable damage and burning due to short–circuiting.
S
Use a cover on the body, the seats, and the floor to
protect them against damage and contamination.
S
Handle brake fluid and antifreeze solution with care
as they can cause paint damage.
S
The use of proper tools, and the required special
tools where specified, is important for efficient and
reliable performance of the service repairs.
S
Use genuine DAEWOO parts.
S
Discard used cotter pins, gaskets, O–rings, oil
seals, lock washers and self–locking nuts. Prepare
new ones for installation. Normal functioning of the
vehicle's components cannot be maintained if these
fasteners and seals are reused.
S
Keep the disassembled parts to assist in reassemb-
ly.
S
Keep attaching bolts and nuts separated, as they
vary in hardness and design depending on the posi-
tion of the installation.
S
Clean the parts before inspection or reassembly.
S
Clean the oil parts, etc. Use compressed air to
make certain they are free of restrictions.
S
Lubricate rotating and sliding faces of parts with oil
or grease before installation.
S
When necessary, use a sealer on gaskets to pre-
vent leakage.
S
Carefully observe all specifications for bolt and nut
torques.
When service operation is complete, make a final check
to be sure service was done properly and the problem was
corrected.
DAEWOO V–121 BL4