Step
1
1. Turn the ignition ON.
2. Check the voltage at the wiper motor connector
terminal 2.
Is the voltage equal to the specified value?
2
Repair the open circuit between the wiper motor
connector terminal 2 and fuse F4.
Is the repair complete?
3
1. Turn the wiper switch to HI.
2. While turning the wiper switch OFF, check the
voltage at the wiper motor connector terminal
1.
Is the specified voltage indicated when the wiper
switch is turned OFF?
4
Replace the wiper motor.
Is there an open circuit?
5
1. Disconnect the wiper relay.
2. Check continuity between wiper relay terminal
31b and 53e.
Does the ohmmeter indicate the specified value?
6
Repair the open circuit between the wiper motor and
the wiper relay.
Is the repair complete?
7
Replace the wiper relay.
Is the repair complete?
DAEWOO V–121 BL4
Windshield Wipers Do Not Return To Park Position
Action
WIPERS/WASHER SYSTEMS 9D – 7
Value(s)
Yes
11–14 v
Go to Step 3
System OK
11–14 v
Go to Step 5
System OK
[ 0 W
Go to Step 6
System OK
System OK
No
Go to Step 2
Go to Step 4
Go to Step 7