Caliper Overhaul - Disassembly (Rear) - Daewoo Nubira Owner's Manual

DAEWOO V–121 BL4
REAR DISC BRAKES 4E – 15
UNIT REPAIR
CALIPER OVERHAUL
Disassembly Procedure
1. Remove the caliper. Refer to"Caliper"in this section.
2. To prevent damage to the piston when removing it,
place a clean shop towel between the piston and
the caliper.
CAUTION : When applying air pressure at the caliper
inlet port, do not place fingers in front of the piston.
The piston will pop out of its bore with enough force
to cause serious injury.
3. Apply unlubricated compressed air to the caliper
inlet port, and progressively increase the air pres-
sure until the piston is forced out of the bore.
4. Remove and discard the outer dust seal.
5. Remove the inner seal and discard it. Do not
scratch the piston bore or the seal groove when
removing the inner seal.
6. Remove the bleeder valve and the dust cover.