Table of Contents
Advertisement
DAEWOO V–121 BL4
HEATING AND VENTILATION SYSTEM 7A – 25
Installation Procedure
1.
Install the new resistor into the heater/air distributor
case with the screws.
Tighten
Tighten the blower resistor retaining screws to 6 NSm
(53 lb–in).
2.
Connect the electrical connector at the resistor.
3.
Connect the negative battery cable.
4.
Confirm the proper performance of the blower.
5.
Replace the footwell upper cover. Refer to Section
9E, Instrumentation/Driver Information.
6.
Replace the glove box. Refer to Section 9E, Instru-
mentation/Driver Information.
HEATER HOSES
Removal Procedure
1.
Partially drain the cooling system. Refer to Section
1D, Engine Cooling.
2.
Compress and slide the two heater hose spring
clamps at the bulkhead rearward.
3.
Gently twist the hose from the left to the right and
back again to loosen the bond between the hose
and the tube.
4.
Remove the end of the hose from the tube.
5.
Repeat Steps 3 and 4 with the other hose.
6.
Compress the heater hose spring clamp on the inlet
coolant line and slide the clamp rearward.
7.
Remove the heater hose from the vehicle.
8.
Compress the heater hose spring clamp at the con-
nection below the intake manifold and slide the
clamp rearward.
9.
Remove the heater hose from the vehicle.
Installation Procedure
1.
Install the left heater hose to the coolant inlet line
fitting. Slide the end of the heater hose over the
coolant fitting until the hose is seated.
2.
Install the right heater hose to the fitting below the
intake manifold. Slide the end of the heater hose
over the fitting until it is seated.
3.
Install and seat the other end of each heater hose.
4.
Compress and slide the spring clamps into position
on the heater hoses and release the tension.
5.
Fill the cooling system. Refer to Section 1D, Engine
Cooling.
6.
Check the hoses for leaks.
- Quick Links:
- Specifications
- Parking Brake Adjustment
Hide quick links:
Advertisement
Table of Contents
