Brake Hose Front Installation - Daewoo Nubira Owner's Manual

4A – 16IHYDRAULIC BRAKES
Installation Procedure
1. Install the new disc brake hose to the caliper with
new seal rings and the bolt.
Tighten
Tighten the front disc brake hose–to–caliper bolt to 40
NSm (30 lb–ft).
2. Slide the brake hose on the steering knuckle shaft
"C" bracket.
3. Connect the brake line to the brake hose on the
wheel housing bracket on each side of the vehicle.
Tighten
Tighten the brake line to 16 NSm (12 lb–ft).
4. Lower the vehicle.
5. Bleed the brake system. Refer to"Manual Bleeding
the Brakes" in this section.
6. Check the brake system for leaks.
DAEWOO V–121 BL4