Limiting Functions - Canon imageRUNNER C3489 Reference Manual

Limiting Functions

If a problem frequently occurs when using the Finishing modes, such as Offset
Collate and Staple, you can temporarily limit the use of these finishing modes by
setting Limited Functions Mode to 'On'.
In addition, when the Service Call Message screen appears indicating a finishing
mode malfunction and you temporally set the Limited Functions Mode to clear the
Service Call Message screen, you can deactivate the Limited Functions Mode by
setting this mode to 'Off' from the Additional Functions screen. However, after the
Limited Functions Mode is deactivated, the Service Call Message screen may
appear again, unless the cause of the malfunction is cleared. (See "Setting the
Limited Functions Mode from the Service Call Message Screen," on p. 8-91.)
NOTE
[Limited Functions Mode] is displayed only if an optional finisher is attached.
1
Press
[Limited Functions Mode].
2
Select [On] or [Off] ➞ press [OK].
NOTE
The Limited Functions Mode is enabled only after you restart the machine (the
main power switch is turned OFF, and then back ON). For instructions on restarting
(turning the main power switch OFF and then ON) the machine, see "Main Power
and Control Panel Power," on p. 1-14.
(Additional Functions) ➞ [Common Settings] ➞
Specifying Common Settings
4
4-61