Before You Use The Terminal; Install And Charge The Battery; Load The Appropriate Software - Symbol Series 3800 Reference Manual

Series 3800 Product Reference Guide

Before You Use the Terminal

The first time you use your Series 3800 terminal, or the first time you power it on after it has
been stored without the battery pack, follow these steps in order.

Install and Charge the Battery

1. Install a battery pack or alkaline battery and carrier in the terminal. Refer to Chapter
6, Maintaining the Series 3800, for instructions.
2. If you hear a repeated tone or see a message on the display, recharge or replace the
battery pack. Refer to Chapter 6, Maintaining the Series 3800, for more information.

Load the Appropriate Software

What software you load and how you load it depends on the environment in which it will be
used:
If this unit is intended for use in batch applications (3805) or in a Spectrum One
!
network environment (3800/3824), refer to Chapter 3, Batch and Spectrum One
Terminal Setup, for information on downloading the software.
If this unit is intended for use in a Spectrum24 network environment (3840), refer to
!
Chapter 4, Spectrum24 RF Terminal Setup, for information on downloading the
software.
1-6