Symbol Series 3800 Reference Manual page 118

Series 3800 Product Reference Guide
To change the current Terminal IP Address, backspace over the current value and
type a new value in decimal form. Each part of the four-part address must be in the
range 0 to 255.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
6. Select Diversity from the main configuration menu. The Diversity screen
(Figure E-7) is displayed.
If Diversity is set to "Yes", the radio firmware attempts to use both antenna ports
for communications. This setting gives better communications if two antennas are
being used with the radio, but distinctly worse communications if only one antenna
is used. For the Series 384X, set Diversity to "Yes".
To change the current Diversity setting, use the
the settings "Yes" and "No".
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
7. Select Terminal Sleep Mode from the main configuration menu. The Terminal Sleep
Mode screen (Figure E-8) is displayed.
If this switch is set "On", the radio is not powered off when an application powers
down the terminal because of inactivity. The terminal can be awakened by a message
E-6
DIVERSITY
2 antennas (Yes/No)
Yes
#$, Clear, Enter
Figure E-7. Diversity Screen
TERMINAL SLEEP MODE
Radio state:
On
#$, Clear, Enter
Figure E-8. Terminal Sleep Mode Screen
cursor keys to toggle between
#$