Batch and Spectrum One Terminal Setup
Introduction
Before using a Series 3800 terminal, perform the following procedures:
Install the battery (refer to Chapter 6, Maintaining the Series 3800)
!
Charge the battery, if using a Nickel Cadmium (NiCd) rechargeable battery (refer to
!
Chapter 6, Maintaining the Series 3800)
Load the system files and application(s).
!
Programs are stored in the terminal's nonvolatile memory (NVM), also called the application
EEPROM.
Hardware Requirements
The following equipment is required to initialize a batch or a Spectrum One radio terminal:
3800 or 3805 terminal
!
One or more 3860 or 3865 cradles, or 3866 CCM
!
OR
PC adapter with Printer Interface Module (PIM)
!
A straight-through RS-232 null modem cable with male DB-25 connector at one end
!
and female DB-25 connector at the other end
Power Supply
!
Host Computer
!
Chapter 3
3-1