Initializing The Series 384X - Symbol Series 3800 Reference Manual

Initializing the Series 384X

To initialize a Series 384X which has LWP.HEX version 3.03 or greater loaded:
Note: This section covers specific settings required on first booting the Series
384X out of the box. For a complete review of the CFG24 screens,
refer to Appendix E, Spectrum24 Utilities.
1. Insert a charged battery in the Series 384X. Refer to Chapter 6 for instructions on
charging and installing a battery.
2. Cold boot the Series 384X.
For the 35-key 384X:
" Press and hold < # + SPACE + FUNC>.
" Press and release PWR.
" Release < # + SPACE + FUNC>.
For the 46-key 384X:
" Press and hold <A + B + D>.
" Press and release PWR.
" Release <A + B + D>.
3. The Series 384X loads software, then brings up the Spectrum24 Configurator
(CFG24) menu, shown in Figure 4-1.
Note: CFG24 comes up automatically after the first initialization out of the
box. On subsequent initializations, type CFG24 at the DOS prompt
to bring up the configurator.
Spectrum24 Terminal Setup
4-3