Symbol Series 3800 Reference Manual page 120

Series 3800 Product Reference Guide
Symbol's BOOTP program accepts setting the following network parameters from
the BOOTP and DHCP parameters:
Sub-net Mask
Default Router (first address from the router list)
Terminal IP Address
To change the current boot mode setting, use the
three valid settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
9. Select Power Management from the main configuration menu. The Power
Management screen (Figure E-10) is displayed.
If power management is set to PSP (default), the radio is powered up only when there
is traffic on the network. This mode adapts to the radio activity to determine how
long the radio is powered down. Because the radio is not always in a ready state
when a message is sent to it, using PSP mode slows response times.
If power management is set to CAM, the radio is always ready to receive. In this
mode, battery life is dramatically reduced.
To change the current power management setting, use the
between the two settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
10. Select Exit from the main configuration menu and press <ENTER> to exit the
configurator and get to a DOS prompt.
11. Cold boot the 3840 to reinitialize the terminal with the changed parameters.
E-8
POWER MANAGEMENT
Radio Power Mode
PSP
#$, Clear, Enter
Figure E-10. Power Management Screen
keys to toggle between the
#$
keys to toggle
#$