Coupling Ccms - Symbol Series 3800 Reference Manual

Coupling CCMs

Up to four 3860 CCMs can be coupled together for table or wall mounting, with power
provided by a single power supply attached to the left-most CCM.
To couple two or more CCMs for table or wall mounting:
1. Verify that add-on 3861-101 kit contains the following parts:
" 1 coupling bracket
" 6 cross-head screws
" 2 flat-head screws
2. On the add-on (or right-hand) CCM, use 3/16-inch driver to remove the jack screws
securing the communications port, ONE AT A TIME, and replace them with the flat-
head screws.
Note: Be sure to remove the jack screws one at a time; otherwise, the
connector will fall into the housing.
3. Place the coupler between the CCMs, aligning the holes in the coupler to the holes
in the CCM's base (Figure 2-6).
4. Install 6 cross-head screws through the coupler into the CCMs and tighten.
5. If you wish to wall mount the coupled CCMs, proceed as directed in Wall Mounting
the CCM.
Screws
Screws
Figure 2-6. Coupling two 3860 CCMs
Coupling
Hardware Setup
2-7