Connecting Power To The 3860 Ccm - Symbol Series 3800 Reference Manual

Series 3800 Product Reference Guide

Connecting Power to the 3860 CCM

Only the power connection is required for charging batteries in the CCM.
1. Install the power supply.
a. Attach the power supply to the left side of the CCM as shown in Figure 2-7 using
two cross-head screws.
b. Connect the power supply plug to an AC wall outlet.
2. When the CCM is connected to power, all the LEDs flash at the same time for 3
seconds, flash once from left to right, and turn on for 3 seconds before going out.
Insert Screw
Power Supply
2-8
LEDs
Insert Screw
Host
Power Port
RS-232
Serial Cable
Figure 2-7. Connecting the 3860 CCM for
Charging and Communications
Communication
Port
3860 CCM