Symbol Series 3800 Reference Manual page 119

directed to it, but not by a broadcast message. If the switch is set to "Off", the radio
is powered off when an application powers down the terminal because of inactivity.
The default setting is "On".
To change the current Terminal Sleep Mode, use the
"On" and "Off" settings.
Press <ENTER> to effect the change. Press <CLEAR> to exit without changes.
8. Select Boot Mode from the main configuration menu. The Boot Mode screen (Figure
E-9) is displayed.
If boot mode is set to "Manual Entry", no configuration messages are broadcast to
the network. The current values of the network parameters which are saved in the
radio's flash, are used to connect to the network. "Manual entry" is the default.
If boot mode is set to "Boot" when the 3840 is initialized, a TCP/IP BOOTP request
message is broadcast to the network. Any boot servers on the network should
response if configured to do so. The terminal accepts the first valid response received.
The response contains an IP address for the terminal's use, and optionally, other
network parameters. Parameters received in this BOOTP response override any
parameters entered through CFG24.
If boot mode is set to "DHCP" when the terminal is initialized, the process is the
same as for BOOTP, except the Dynamic Host Configuration Protocol is used.
Spectrum24 Network and Flash Disk Utilities
BOOT MODE
IP address from:
DHCP
#$, Clear, Enter
Figure E-9. Boot Mode Screen
keys to toggle between the
#$
E-7