Setting Up The Scanner; Installing The Interface Cable; Connecting Power (If Required) - Symbol LS9203 Product Reference Manual

Setting Up the Scanner

Installing the Interface Cable

Connect the interface cable to the host computer.
1.
Plug the interface cable modular connector into the interface cable port on the rear of the scanner (see
2.
1-2).
Push the connector into the housing until a "click" sound is heard. The green LED lights up and three short high
3.
beeps sound, indicating that the scanner is operational.
Cable interface
port
Installing the Interface Cable
Figure 1-2
NOTE Different cables are required for different hosts. The connectors illustrated in each host chapter are
examples only. The connectors may be different than those illustrated, but the steps to connect the
scanner remain the same.

Connecting Power (if required)

If the host does not provide power to the scanner, an external power connection to the scanner is required:
Connect the interface cable to the back of the scanner, as described in
1.
Installing the Interface Cable on page
Connect the other end of the interface cable to the host (refer to the host manual to locate the correct port).
2.
Plug the power supply into the power jack on the interface cable.
3.
Plug the other end of the power supply into an AC outlet.
4.
1-3.
Getting Started 1 - 3
Figure
Interface cable
modular connector