To Change The Split Point - GEM genesys xp Owner's Manual

owner's manual
F1-F2 DYNAMIC ARRANGE
Activating this function the volume of the Style Auto
accompaniments is controlled according to the velocity
applied to the chord notes. Increased chord note velocity
increases the volume of the accompaniments. When Off, the
accompaniment volumes remain unchanged with changes in
chord note velocity.
F3- F4 AUTOBACKING
When AUTOBACKING is on, a quick change of chord
updates the Style auto accompaniment pattern instantly
without "breaks" in the pattern. When off, a change of chord
does not update instantly but waits for the next note of the
accompaniment before revising the pattern.
NOTE:
The Split Point is a general parameter (not linked to a particular memories) which is conserved in memory when the instrument
is turned off. The new setting is lost when the "Reset All" operation is carried out or if the backed-RAM loses its data due to
the total discharge of the battery.
Realtime use of the Genesys xp
Switching to a new style, the mix would normally be replaced
by the preprogrammed mix that has been stored in this
style. To avoid this, turn on the MIXER LOCK function. Now
the mixing control of each style you select has to be fixed
manually.
Activating the function, the notes of the track assigned to the
left hand (Accomp. split mode) are held even if the left hand
is taken away from the keys. The Lower Memory function is
useful for holding on 'background' sounds without having
to use a Damper pedal (which may be of more use with the
upper sounds).

To change the split point

3 Press ENTER to confirm
genesys xp
F5-F6 MIXER LOCK
F7-F8 KEY MEMORY
Press The function buttons
1
F7-F8 (SPLIT)
The split point set screen
appears in the display
Modify the default split point by rotating the
2
DIAL, or pressing on your control keyboard the
key where you want to split the keyboard
Page77