Control I/O; Figure 3.15 Control I/O Connection, Printer Back Panel - Kodak DP5120 Installation Manual

Control I/O

If the installation requires connecting the printer to a 200 or 220 system
controller, an I/O box, or to an external device activated by sort codes, the
control I/O connection can be used with one of the following cables:
• CABLE ASSY-SIGS SORT CODE ADPT (0139375).
This cable adapts the control I/O connector to the J1 connector on the
system controller I/O board, or to an I/O box using the same 40-pin
connector.
• CABLE ASSY-SIGS SORT CODE ADAPT (24") 0178602.
This cable adapts the control I/O connector to the cable used for the
SORT / STOP (relay contact closure) cable. This cable typically goes
to a stacker, sorter, or other inline device activated by sort codes
embedded in the image data being printed.
Either cable is connected to the CONTROL I/O connector on the printer
back panel (see Figure 3.15).
For detailed information on the signals used by the Control I/O cable, see
the Service Guide.
Figure 3.15
Control I/O
Control I/O connection, printer back panel
Chapter 3. Printer Installation
Printer Connections
Installation Guide 3-15