Chapter 6. Testing
Printhead Adjustment
Figure 6.2
Dark defect, defines low end of print window
6-8
DP5000 Series Printers
Caution: Operating the printer at voltages below the low-end setting of the print
window causes increased dark defects. As the voltage drops further,
streakers appear.
7. Select Mode
volts above the low-end setting.
8. Press APPLY to save this setting.
9. Print another test pattern to verify the phase and voltage settings.
If print quality is unsatisfactory, repeat both procedures.
→
→
Settings
Printer Setup and enter a value 10