9. On the main Service View screen, select Data Test and A Test
Image then START TEST.
10. You can also run a test job from the Production screen, or press the
[TEST PRINT] button on the printer operator panel.
11. To stop printing, press [TEST PRINT] again.
12. Check the test patterns.
13. If test patterns print, check the print quality. If the print quality is
acceptable, the system is operational, and the installation is
complete. Continue with the installation report.
14. If print quality is not acceptable, adjust the printhead phase and
voltage (see "Printhead Adjustment").If test patterns do not print, run
full diagnostics starting with the printhead (see "Fluidics Tests" in
Chapter 1, and "Diagnostics" of the Service Guide).
Chapter 6. Testing
System Tests
Installation Guide
6-5