Chapter 4. System Installation
Installing Software
Monitor power cord
PC power cord
Installing Software
4-8
DP5000 Series Printers
Power Cables
The system controller PC has the following two component power cables:
•
PC power cable
•
Monitor power cable.
The two cables are the same; both are CORD-JUMPER ACC UL/CSA
<HAR> M/F 10A/250V 8'- 2" (2.5m), part number 0100238-217. These
cables are shipped in the components boxes.
Plug the female ends of the cables into the power receptacles on the PC
and monitor (see Figure 4.9). Route the cables down into the cabinet
through the cutout in the top, and plug the male ends of the cables into
110V receptacles in the front of the power distribution panel inside the
cabinet.
Figure 4.9
PC and monitor power cables
Install the CS150 system controller software on the controller PC.
The installation of the software package is described in the document
shipped with the system software CD-ROM, either Getting Started Guide
(0113994-602) or software Installation Guide (0114083).