Kodak DP5120 Installation Manual page 33

Printer Positioning
Chapter 3.
Printer installation consists of the following procedures:
• Printer positioning
• Fluid container installation
• Voltage selection (not required for DP5122)
• Printer connections.
To ensure that you complete all steps of the procedures, complete the
"Printer Checklist" in Appendix A.
The unpacked printer is ready to be positioned for operation. The
following sections describe positioning the printer on one of the following
operating locations:
• Printer stand
• Customer-supplied support.
!
WARNING
Two persons are required to lift and move the printer. Do not attempt to
move or carry the printer alone.
Printer Stand Installation
Use the following procedure to install the printer on the rollaround printer
stand:
1. Position the assembled stand next to the printer shipping pallet.
2. Remove the packing material from the pallet to clear the base of the
printer (all four bottom edges of the printer enclosure).
3. Locate the four holes in the top of the stand that correspond to the
printer feet. Orient the stand with its sliding doors at the front of the
printer (the operator panel end).
Note: The stand is rectangular and the printer fits only in one orientation.
4. Holding the printer baseplate, lift the printer off the pallet and set it on
the stand (see Figure 3.1). Set the rubber printer feet on the holes in
the stand top.
Caution: Do not lift the printer by holding only the umbilical hanger. The hanger will
bend or break if it bears the full weight of the printer. Support some of the
weight of the printer with one hand under the baseplate, and then you can
grip the hanger to lift with your other hand.
Printer Installation
Installation Guide 3-1